My Pool-B pH Swimming Pool Control Station

Rx swimming pool control station
MY POOL/B S Rx (3 l/h, 3 bar) CXB 30 031 03

This equipment refers to a peristaltic pump with built-in Rx controller.

The supplied set includes the following items:
  - Rx electrode;
  - 1/2” electrode holder;
  - level sensor;
  - suction filter;
  - 3/8” injection valve;
  - Rx475 buffered solution;
  - 2 х 2 m inlet and outlet hoses

Principle of Operation:

Peristalsis refers to a series of automatic contractions that promotes a dosed drug through a pipe or a hose. The rollers squeeze the hose wall, mechanically simulating the biological effects of peristaltic.Thus, they form a plug that is moving through the hose in terms of movements of the rollers. The previously passed section straightens out, and the liquid flows into the created vacuum.

The liquid will move through the hose as long as it is not entirely straightened; at this moment, the second roller starts its movement, to prevent reverse fluid movement through the hose. It acts similarly. At the same time the rollers, moving with a help of a special motor, create not only the suction force, but also the output pressure of the pump.

Technical Specification:

• accordance with СЕ norms;
• GW PLAST© antacid plastic housing;
• level sensor support;
• standard electric power supply: 230V, 50 Hz, single-phase (differentials less than ±10%);
• electric power supply upon request (differentials less than ±10%): 110 V, 50-60 Hz, single-phase.

Flow Part’s Constructing Materials:

1. Hose: Santoprene®
2. Inlet filter: Polypropylene
3. Inlet hose: PVC Cristal®.
4. Outlet hose: polyethylene.

TECHNICAL CHARACTERISTICS:

MyPOOL Specification:

MyPOOL features easy operation; it is constructed on the base of a peristaltic pump with an electronic scanner that provides automatic dosing and control over  physical and chemical features of swimming pool water, namely pH level and ORP (oxidation-reduction potential, mV). There are two available dosing modes: ON-OFF and proportional one. Both modes are applicable when the difference between the measured value and the set one is more than 0.4pH (for MyPOOL PH) or 30 mV (for MyPOOL RX). The proportional mode is applicable when the difference is less, depending on the determined modes. They are as follows:

MyPOOL pH (factory setting): installation point = 7,2 pH; dosing mode = ON/OFF; dosing assignment = acid
MyPOOL RX (factory setting): installation point = 700 mV; dosing mode = ON/OFF; dosing assignment = oxidation

Overall Dimensions: