TR drum transfer pumps for drums and tanks

TR drum transfer pumps for drums and tanks


 
TECHNICAL CHARACTERISTICS:
  • Flow rate up to 90 m³/min.
  • Construction materials are as follows: PP, PVDF, AISI 316;
  • Suitable for corrosive liquids;
  • Dip tube length ranges from 900 mm to1200 mm;
  • Viscosity up to 600 cps;
  • Portable and easily dismantled;
  • Compatibility: available with either electric or pneumatic motor;
  • Adjustable flow rate (pneumatic version);
  • No seals inside;

Pumping various liquids out of various tanks, drums, and containers.

 
Description

Debem drum chemical pumps are designed for pumping both neutral and highly aggressive liquids out of drums, containers, baths, etc.

Drum pumps make it maximally easy to empty drums and other tanks or to transfer liquids from one tank to another.

Various construction materials of flow part ranging from chemically resistant plastic to highly alloyed stainless steel provide the possibility to pump almost any medium including highly concentrated acid solutions and their mixtures.

Single-phase or three- phase high speed electric motors, as well as pneumatic motors function as a pump drive.

Explosion-proof stainless steel pumps equipped with electric or pneumatic pumps are applied to explosive environments.

 
Pump Capacity
Electric drum transfer pumps Pneumatic drum transfer pumps

TR Electric drum transfer pumps

TR P-EL, TR F-EL, TR A-EL

TR Pneumatic drum transfer pumps

TR P-PN, TR F-PN, TR A-PN

TR P-EL TR F-EL TR A-EL

TR P-PN TR F-PN TR A-PN

Model TR P – PN TR F - PN TR A - PN TR P - EL TR F - EL TR A - EL
Tube material ПП PVDF AISI 316 ПП PVDF AISI 316
Tube diameter, mm 42 40 42,5 42 40 42,5
Tube length, mm 900/1200
Shaft material Hastelloy Hastelloy AISI 316 Hastelloy Hastelloy AISI 316
Bushing material PTFE
Material for impeller ECTFE
Suction hose PP ECTFE ECTFE PP ECTFE ECTFE
Additional parts PP+PTFE PVDF+PTFE PTFE+PPS-V PP+PTFE PVDF+PTFE PTFE+PPS-V
Hose diameter, mm 25
Temperature 50 85 85 50 85 85
Motor type Pneumatic Electric
Motor power 0,5 HP А 7 bar 500 W /800 W
Voltage       230 V
Motor protection       IP 54
Description


These drum transfer pumps consist of a dip tube, at the end of which there is the open impeller fitted to the drive shaft.  The last one is connected to the pump by means of a ring nut. At the same time, transmission is provided by a shaft coupling.

A = drive coupling
B = motor ring nut
C = bearing
D = delivery duct
E = dip tube
F = PTFE bushing
G = impeller
H = suction port
I = shaft
Description TR Description TR
Installation

The centerline of TR pumps is to be installed only vertically, the pump itself is to be fully immersed into a tank and to work, providing there is liquid in the tank. Dry run or presence of air bubbles can lead to bushing damage.

 

ATTENTION!

Dry run or presence of air bubbles can lead to bushing damage!

Installation